High pressure Oil seal VKD 92-110-10 for engine

Short Description:

An oil seal is a device part used in a machine to prevent fluid (mostly lubricating oil) from escaping from joints (mostly the joint surface of parts or rotating shafts).  Static seal and dynamic seal (general reciprocating motion) with seals called seals.

Product Detail

Product Tags

Product Details




100 sets


Color box  and carton


Suitable for all industries (motors, crankshafts, gearboxes, screw compressors, etc.)





Place of origin

Zhejiang China



Product Features

Good oil and fuel resistance
High tensile strength
Low swelling in water
After-sales service: warranty period :2 years

Install Method of oil seal

When installing, please place the oil seal horizontally on the cavity hole for uniform pressure.  Avoid the oil seal is forced into the tilt state, resulting in damage or stuck parts of the oil seal, resulting in oil seal leakage.
If there is no press or press cannot be used on site, please use special fixture to avoid direct hammering with hammer, otherwise there will be deformation and other consequences.
When installing oil seal, please use special fixture to avoid oil seal tilt.


If the shaft diameter surface roughness is low or there are rust spots, rust, burr and other defects, to use fine emery cloth or whetstone polished smooth; Apply cleaning oil or lubricating grease to the corresponding position of oil seal lip or shaft diameter. The outer ring of the oil seal is coated with sealant, and the key slot on the shaft is wrapped with hard paper to avoid scratching the lip of the oil seal. The oil seal is rotated and pressed inward with special tools, and must not be hard hit and hard rushed to prevent the deformation of the oil seal or the failure of the spring; If there is lip flanging, spring off and oil seal askew must be removed and re-loaded. It should be noted that when the shaft diameter is not worn and the oil seal spring is enough, do not tighten the inner spring without authorization.When the oil seal applied to machinery is in bad working conditions, large temperature difference in the environment, much dust, and frequent vibration of the machine parts, the stress condition is constantly changing, it should be checked, maintained and maintained frequently.

  • Previous:
  • Next:

  • Write your message here and send it to us